![]() In addition, you should also use the "ipconfig" command in the destination computer to make sure you have the correct IP and MAC address. If you have a laptop, make sure it's connected to a power source to allow the feature to work as expected.įinally, if you suspect a networking problem that may prevent the magic package from waking up the remote computer, you can use the "ping" command to check the connectivity. If the computer is off, you can look at the Ethernet adapter, and if you see blinking lights, it indicates that the adapter is active. On Windows 11, the ability to power on a computer remotely will only be available when the network adapter is active and reachable within the network. If the option is not present in the motherboard's firmware or the network adapter's properties, the feature may not be available for your computer.Īfter enabling Wake on LAN, you may also need to disable fast startup to make the feature work. In case you have a USB network adapter, Wake on LAN may only work when the device is in the sleeping state mode because turning off the computer will stop providing power to the USB port. If you sent the wake command, but the computer is not turning on, there are a few troubleshooting steps you can follow. How to troubleshoot WoL problems on Windows 11 Click the download link to save the app on your device.Īfter you complete the steps, use the network addresses to send a magic packet to wake up a device remotely with your particular application.You have been warned.įor this guide, we picked the "WakeMeOnLan" tool from NirSoft to wake a device remotely: Warning: The app we are using works as advertised, but it's a third-party tool, and you should use it only at your own risk. You may also be able to wake a device through the WoL feature built into the router. You can use virtually any third-party application for Windows, Linux, Mac, mobile apps for Android and iPhone, or custom scripts to send a magic wake-up packet. Place your computer in Sleep or Hibernate mode ( Start > Power > Sleep / Hibernate ), and press the Wake button on the Wake On Lan app. Once you've added your computer to the app, it's time to see if it works. Also, you may want to disable the feature inside the firmware. Choose a nickname for the device and choose the appropriate Wi-Fi network. You can always disable the WoL feature using the same instructions mentioned above but on step 9, make sure to disable the option and other settings you may have selected. While the computer isn’t powered on yet, press and hold the F2 key of the keyboard, and then press the Power button (Do not release F2 key until the BIOS. Enable the Wake on LAN feature in BIOS configuration. After you complete the steps, you can proceed with the instructions to use a third-party tool or script to send a wake-up packet over the network to the device you want to start. Select the Power Management tab, check the box to Allow this device to wake the computer, and then select OK.
0 Comments
Leave a Reply. |